SHENGYA (VINCENT)

CS-3 CLASS A PRE-AMPLIFIER x 1 plus

PSM-300 CLASS A POWER AMPLIFIER MONO BLOCKS x 2

GENERAL:

Pre-amplifier:

Fully balanced dual mono circuit design

2 power transformers in shielded boxes: 1 for each channel

ShengYa (Vincent) exclusive DC amplification modules

Wide frequency response, extremely low distortion

No op amps employed

Japan made high-end volume control for long life and noble sound

Full remote control function

Class A output stage (MOSFET)

High gain / Low gain selection for fine sonic matching with sources

6 pairs of inputs: 5 pairs RCA + 1 pair XLR balanced

3 pairs of outputs: 2 pairs RCA + 1 pair XLR balanced

Detachable power cord system (IEC)

Power Amplifier:

Serious upgrade to the famous SP991+

Fully balanced dual mono blocks with zero interchannel interference

Input signal amplification by MOSFET

1500W high grade massive transformer for each block

120000uF high-end electrolytic capacitors for each channel

Output stage employs 12 pairs of output transistors for each block

Effortless control over any hard to drive or low impedance speakers

Selectable 100W pure class A output / 300W class AB output

Incorporated with RCA / XLR balanced input selector  

2 pairs of inputs: 1 pair RCA + 1 pair XLR balanced

2 pairs of speaker output terminals (each block) for

Very convenient bi-wiring connection

Detachable power cord system (IEC)

TECHNICAL:

Pre-amplifier:

Rated Output Voltage: 2V

Frequency Response: 20Hz to 20KHz, +/- 0.5db

SN Ratio: > 90db (Wide frequency band)

Distortion THD: <0 .1% (1Khz, 2V)

Input Impedance: 47Kohms

Input Sensitivity: 450mV (RCA)

Dimensions: 446mm (W) x 113 mm (H) x 420mm (D)

Power Amplifier:

Rated Power Output: 300W (8ohms),

                                        600W (4ohms),

                                        1200W (2ohms)

Pure Class A Power Output: 100W

Frequency Response: 20Hz to 20KHz, +/- 0.5db

S/N Ratio: > 90db (Wide frequency band)

Total Harmonic Distortion: <0 .1% (1Khz, 1W)

Input Impedance: 47Kohms

Input Sensitivity: 1.1V

Dimensions: 446mm (W) x 216 mm (H) x 560mm (D)

PURCHASE ON CS-3 CLASS A PRE-AMPLIFIER

PURCHASE ON PSM-300 POWER AMPLIFIER MONO BLOCKS

Voltage Standard Available: 220V, 230V

Further Questions: info@cattylink.com

After sales and Warranty: service@cattylink.com